System Log - D-Link DES-3326SR Manual

System Log

The menu links to set up a System Log are located in their own subdirectory in the Advanced Settings folder.
The log may be configured and later disabled without losing the configuration using the System Log State menu.
Configure System Log State
To enable the System Log Server settings, select Enabled
and click the Apply button in the System Log State menu.
Any server settings that have been configured will be
retained regardless of whether the system log is on or off.
The switch can send system log messages to up to four designated servers. Use the System Log Server menu to
configure IP settings and the type of messages sent.
Figure 12- 2. System Log Server list
The parameters configured for adding and editing System Log Server
settings are the same. See the table below for a description.
D-Link DES-3326SR Layer 3 Switch
72
Chapter 12
Figure 12- 1. System Log State menu
Click the New button to add a new server setup.
Select an existing entry and click the Edit button to
change the entries settings. To remove an entry,
select it and click on the Delete button.
Figure 12- 3. System Log Server – Add