Connect To Rps - D-Link DES-3326SR Manual

Connect to RPS

The DPS-200 is connected to the Master Switch using a 14-pin DC power cable. A standard, three-pronged AC
power cable connects the redundant power supply to the main power source.
Insert one end of the 14-pin DC power cable into the receptacle on the switch and the other end into the redundant
Using a standard AC power cable, connect the redundant power supply to the main AC power source. A green LED
on the front of the DPS-200 will glow to indicate a successful connection.
Re-connect the switch to the AC power source. On certain switches, such as the DES-3326SR, an LED indicator will
D-Link DES-3326SR Layer 3 Switch
Figure 2 - 14. Connect RPS to Switch
show that a redundant power supply is now in operation.
No change in switch configuration is necessary for this installation.
NOTE:
See the DPS-200 documentation for more information.
CAUTION:
Do not use the Switch with any redundant power system other than
the DPS-200.
power supply.
30