D-Link DES-3326SR Manual page 165

The following RIP settings can be applied to each IP interface:
Parameter
Interface Name
TX Mode <Disabled>
RX Mode <Disabled>
Password
Authentication
State
D-Link DES-3326SR Layer 3 Switch
Description
The name of the IP interface on which RIP is to be setup. This interface
must be previously configured on the Switch.
Toggle among Disabled, V1 Only, V1 Compatible, and V2 Only. This entry
specifies which version of the RIP protocol will be used to transmit RIP
packets. Disabled prevents the transmission of RIP packets.
Toggle among Disabled, V1 Only, V2 Only, and V1 or V2. This entry
specifies which version of the RIP protocol will be used to interpret
received RIP packets. Disabled prevents the reception of RIP packets.
A password to be used to authenticate communication between routers on
the network.
Toggle between Disabled and Enabled to specify that routers on the
network should us the Password above to authenticate router table
exchanges.
Toggle between Disable and Enable to disable or enable this RIP interface
on the Switch.
155