Basic Setup; Switch Information - D-Link DES-3326SR Manual

D-Link DES-3326SR Layer 3 Switch

Basic Setup

The subsections below describe how to change some of the basic settings for the Switch such as changing IP
settings and assigning user names and passwords for management access privileges, as well as how to save the
changes and restart the Switch. The menus to perform these tasks are located in the Basic Setup folder. The
hyperlinked menu buttons in this folder include: Switch Information, Basic Switch Setup, Serial Port
Settings, Port Configurations, Port Security Settings, Traffic Segmentation Table, User Accounts, Factory
Reset, Save Changes and Restart System. Most of these menus and the subdirectorys located in the Basic
Setup folder are discussed in later chapters. The subdirectories include: SNTP Settings, Network Management,
Switch Utilities and Network Monitoring.

Switch Information

The first page displayed upon logging in
presents the System Information menu. This
page can be accessed at any time by clicking
the Switch Information button in the Basic
Setup folder.
The System Information page displays
general information about the Switch
including its MAC Address, Hardware Boot
PROM and Firmware versions, and installed
module information. To view the same
information using the CLI interface use the
command show switch (this will also
display IP settings information).
Figure 3- 2. Switch Information menu
35