D-Link DES-3326SR Manual page 182

For stub area, Type 3 summary link advertisements can also be used to describe a default route on a per-area
basis. Default summary routes are used in stub area instead of flooding a complete set of external routes. When
describing a default summary route, the advertisement's Link State ID is always set to the Default Destination −
0.0.0.0, and the Network Mask is set to 0.0.0.0.
Separate costs may be advertised for each IP Type of Service. Note that the cost for TOS 0 must be included,
and is always listed first. If the T-bit is reset in the advertisement's Option field, only a route for TOS 0 is
described by the advertisement. Otherwise, routes for the other TOS values are also described. If a cost for a
certain TOS is not included, its cost defaults to that specified for TOS 0.
Table 12. Summary Link Advertisement
Field
Network Mask
TOS
Metric
D-Link DES-3326SR Layer 3 Switch
Summary Link Advertisements
Link-State Age
Link-State ID
Advertising Router
Link-State Sequence Number
Link-State Checksum
Network Mask
TOS
Description
For Type 3 link state advertisements, this indicates the destination
network's IP address mask. For example, when advertising the
location of a class A network the value 0xff000000
The Type of Service that the following cost is relevant to.
The cost of this route. Expressed in the same units as the
interface costs in the router links advertisements.
172
2
Options
Length
Metric