Configure Bandwidth Control - D-Link DES-3326SR Manual

Configure Bandwidth Control

The bandwidth control settings are used to place a ceiling on the transmitting and receiving data bit rates for any
port.
To change the maximum allowed bandwidth for a given port:
Figure 10- 5. Bandwidth Control Table
D-Link DES-3326SR Layer 3 Switch
Click the selection button in the far left column that corresponds to
the port you want to configure and click the Edit button. A new
dialog box used to edit bandwidth settings opens.
To limit either the Rx or Tx rates, deselect the No Limit check box
and type the desired rate. Rates can be expressed using whole
numbers up to the maximum available rate for the port.
Click on the Apply button to put the bandwidth limits into effect.
69
Figure 10- 4. Edit Port Bandwidth