Table of Contents
Advertisement
Next step
Install the integrated storage controller
Installing the integrated storage controller card
Prerequisite
Follow the safety guidelines listed in
Steps
1
Angle the integrated storage controller card and align the end of the card with the controller card connector on the system board.
2
Lower the connector side of the integrated storage controller card into the integrated storage controller card connector on the system
board.
NOTE:
Ensure that the slots on the system board align with the screw holes on the integrated storage controller card
connector.
Figure 71. Installing the integrated storage controller card
3
Route the integrated storage controller card cable along the wall of the system.
4
Align the screws on the integrated storage controller card cable with the screw holes on the connector.
5
Using Phillips #2 screwdriver, tighten the screws to secure the integrated storage controller card cable to the card connector on the
system board.
124
Installing and removing system components
card.
Safety
instructions.
Advertisement
Table of Contents
