Honda FRC800 Owner's Manual page 37

SERVICING YOUR TILLER
4. Clean both filter elements, if they are to be reused.
Foam element: Clean in warm soapy water, rinse and allow to dry
thoroughly, or clean with a high flash point solvent and allow to dry.
Dip the element in clean engine oil and squeeze out all the excess oil.
Excess oil will restrict air flow through the foam element and may
smoke at the engine start.
Paper element: Tap the filter element several times to remove dirt
or blow compressed air (not exceeding 207 kPa, 2.1 kgf/cm3, 30
psi) through the filter from the clean side that faces the engine.
Never try to brush off dirt; brushing will force dirt into the fibers.
5. Install the foam element onto the paper element.
6. Wipe dirt from the
inside of the air
cleaner cover using a
moist rag.
AIR CLEANER WING NUT
Remove the five 5
x
16.5 m m pan screws
and remove the pre
5 x 1 6 . 5 m m CLEANER
air cleaner guide and
case.
Clean air cleaner
cover and case.
Assemble the pre air
cleaner case and
guide by aligning tab
of the case with the
GU,DE
groove of the case
cover.
PAN SCREW(5)
7. Reinstall the filter
elements and
grommet and tighten
PR
the wing nut. Install
CLEANER
the air cleaner cover
and tighten the wing
nut.
CASE
35