Installing Generic Mounting Brackets - Gateway 7400 Rack Mounting Instructions

Installing generic mounting brackets

If you are installing the server in a non-Gateway cabinet, use the generic
mounting brackets. These brackets allow for different cabinet depths. If
generic mounting brackets are already installed in the cabinet, go to
"Installing the cabinet mounting rails onto generic brackets" on page 13.
To install the generic mounting brackets in the cabinet:
1
If you received a mounting template with your cabinet, use it to locate
the exact position of the cabinet mounting brackets.
2
Position the front mounting bracket (shorter bracket) on the front vertical
mounting rail.
3
Attach the front mounting bracket to the front vertical mounting rail
using two screws from the accessory kit.
If screw holes are not threaded in the front vertical mounting rail, attach
the front mounting bracket by using the screws and bar nut from the
accessory kit.
Front vertical
mounting rail
Front mounting
bracket
4
Position the back mounting bracket (longer bracket) on the back vertical
mounting rail.
12
Installation
Bar nuts
Back vertical
mounting rail
Back mounting
bracket