Installing The Cabinet Mounting Rails Onto Generic Brackets - Gateway 7400 Rack Mounting Instructions

5
Attach the back mounting bracket to the back vertical mounting rail
using two screws from the accessory kit.
If screw holes are not threaded in the back vertical mounting rail, attach
the back mounting bracket by using the screws and bar nut from the
accessory kit.
6
Mount the second set of brackets on the opposite side of the cabinet by
repeating Steps 2 through 5.
Installing the cabinet mounting rails onto
generic brackets
To install the cabinet mounting rails onto generic brackets:
1
Align the back end of the cabinet mounting rail to the back mounting
bracket by sliding the inner rail forward (if the spring latch locks the inner
rail into place, free the rail by releasing the spring latch).
Front vertical
mounting rail
Front mounting
bracket
Inner slide
2
Attach the back end of the cabinet mounting rail to the back mounting
bracket using two screws, nuts, and star washers from the accessory kit.
One screw must be located in the last back bracket screw hole. The second
screw can be located in any of the other back bracket long screw holes.
Spring latch
Inner rail
Installing the cabinet mounting brackets and mounting rails
Star washer
Hex nut
Back mounting
bracket
Back vertical
mounting rail
13