Installing The Outriggers And Castors - Gateway 930 series System Manual

Installing the outriggers and castors

The tower chassis is shipped with small rubber feet to prevent it from slipping
and to minimize vibrations when the chassis is placed on a desktop. However,
if you intend to place the chassis on the floor, you may find it easier to
maintain the system if you install the outriggers and castors (included), which
let you roll the server out for easier access.
To install the outriggers and castors:
1
Gently turn the chassis upside down, resting it on the top panel.
2
Align the outriggers and castors with the slots on the bottom panel of
the chassis.
3
Place the tabs on the outriggers into the corresponding slots on the
bottom panel and slide the outriggers toward the ends of the chassis.
4
Carefully return the chassis to the upright position.
16
System Setup