Table of Contents
Advertisement
Processor Air Baffles
Rear Processor Air Baffle
To remove the rear processor air baffle:
1. Remove the front bezel door (tower model only), and lay the server on its side with the
access panel facing upward. Refer to "Removing the Front Bezel Door (Tower Model
Only)" in this chapter.
2. Remove the access panel. Refer to "Removing the Access Panel" in this chapter.
3. Remove the rear processor air baffle by loosening the two thumbscrews that secure it to
the system tray (1).
4. Lift the air baffle up and out of the server (2).
Figure 2-19: Removing the rear processor air baffle
Reverse steps 1 through 4 to replace the rear processor air baffle.
Front Processor Air Baffle
To remove the front processor air baffle:
1. Remove the front bezel door (tower model only), and lay the server on its side with the
access panel facing upward. Refer to "Removing the Front Bezel Door (Tower Model
Only)" in this chapter.
2. Remove the access panel. Refer to "Removing the Access Panel" in this chapter.
3. Remove the rear processor air baffle. Refer to "Processor Air Baffles" in this chapter.
HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide
CAUTION: The removal and replacement of the rear and front processor air baffles must
be completed within 1 minute to prevent possible overheating and damage to hardware.
Removal and Replacement Procedures
2-29
Advertisement
Table of Contents
