Processor Power Modules (Ppms) - HP ProLiant ML570 Generation 2 Maintenance And Service Manual

Processor Power Modules (PPMs)

1. Prepare the server for a non-hot-plug procedure. Refer to "Preparing the Server for
Non-Hot-Plug Procedures" in this chapter.
2. Remove the front bezel door (tower model only), and lay the server on its side with the
access panel facing upward. Refer to "Removing the Front Bezel Door (Tower Model
Only)" in this chapter.
3. Remove the access panel. Refer to "Removing the Access Panel" in this chapter.
4. Remove the rear and front processor air baffles. Refer to "Processor Air Baffles" in this
chapter.
5. Loosen the thumbscrew on the processor retaining bracket (1).
6. Lift the processor retaining bracket upward (2).
Figure 2-32: Lifting the processor retaining bracket
HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide
Removal and Replacement Procedures
2-43