Install The Access Panel; Remove The Processor Air Baffle - HP ProLiant ML370 G5 User Manual

NOTE: If the locking latch is locked, use a Torx T-15 screwdriver to unlock the latch.

Install the access panel

Place the access panel on top of the server with the hood latch open. Allow the panel to extend past
1.
the rear of the server approximately 0.8 cm (0.2 in).
Engage the anchoring pin with the corresponding hole in the latch.
2.
Push down on the hood latch. The access panel slides to a closed position.
3.

Remove the processor air baffle

Power down the server (on page 20).
1.
Extend or remove the server from the rack
2.
Remove the access panel (on page 25).
3.

Remove the processor air baffle.

4.
("Extend the server from the rack" on page 22).
Operations 26