Processor Air Baffle; Power Supply Module - HP ProLiant DL160 Gen8 Maintenance And Service Manual

Remove the server from the rack (on page 28).
o
Open the locking latch, slide the access panel to the rear of the chassis, and then remove the access
4.
panel.
If the locking latch is engaged, then use a T-15 Torx screwdriver to unlock the latch.

Processor air baffle

To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 28).
o
Remove the access panel
4.
Remove the processor air baffle.
5.
To replace the component, reverse the removal procedure.

Power supply module

To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Access the product rear panel.
3.
("Access panel" on page 29).
Removal and replacement procedures 30