Removal and Replacement Procedures
3. Loosen the thumbscrews on the front of the chassis (1).
4. Use the Torx T-15 tool that ships with the server to loosen the retaining screw located on
the front of the chassis next to the two thumbscrews (2).
5. Slide the access panel toward the back of the server, and lift it away from the chassis (3).
Figure 2-7: Removing the access panel
Reverse steps 1 through 5 to replace the access panel.
Opening the System Tray
To open the system tray:
1. Remove the access panel. Refer to "Removing the Access Panel" in this chapter.
2-10
HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide