HP ProLiant ML570 Generation 2 Maintenance And Service Manual page 57

To remove the server from the rack:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Loosen the thumbscrews that hold the cable management arm bracket to the back of the
server (1).
3. Slide the cable management arm bracket up and remove it from the server (2).
Figure 2-27: Removing the cable management arm
4. Loosen the front panel thumbscrews and pull the server out of the front of the rack until it
stops in the extended position.
5. Press the release latches.
Figure 2-28: Pressing the release latches
HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide
Removal and Replacement Procedures
2-39