Processor Air Baffle - HP ProLiant ML370 Maintenance And Service Manual

Processor Air Baffle

To remove the processor air baffle:
1. Power down and remove power from the server. Refer to "Powering Down the Server" in
this chapter.
2. Unlock and open the front bezel (tower server only).
IMPORTANT: You must unlock the tower bezel before removing the access panel. Refer to "Front
Bezel" in this chapter.
3. Remove the access panel. Refer to "Access Panel" in this chapter.
4. Loosen the two thumbscrews that secure the air baffle to the center wall (1).
5. Lift the air baffle up and out of the server (2).
Figure 2-32: Removing the processor air baffle
To replace the processor air baffle, reverse steps 4 and 5.
HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide
Removal and Replacement Procedures
2-35