Table of Contents
Advertisement
Reverse steps 1 through 11 to replace the PCI backplane.
System Tray
To remove the system tray:
1. Prepare the server for a non-hot-plug procedure. Refer to "Preparing the Server for
Non-Hot-Plug Procedures" in this chapter.
2. Remove the front bezel door (tower model only), and lay the server on its side with the
access panel facing upward. Refer to "Removing the Front Bezel Door (Tower Model
Only)" in this chapter.
3. Remove the access panel. Refer to "Removing the Access Panel" in this chapter.
4. Remove the processor air baffles. Refer to "Processor Air Baffles" in this chapter.
5. Remove the memory boards. Refer to "Removing a Memory Board" in this chapter.
6. Disconnect cables to all PCI expansion boards.
7. Remove any expansion boards from the PCI slots. Refer to "Expansion Boards" in this
chapter.
HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide
WARNING: To reduce the risk of personal injury or damage to the equipment, do not
use the system tray handle to lift or move the ProLiant ML570 Generation 2 server.
Removal and Replacement Procedures
2-51
Advertisement
Table of Contents
