Table of Contents
Advertisement
CSG14 Series Gigabit Converter Switch
The connection procedure is straightforward. Simply insert the DC leads to the
CSG14H's power terminals, positive (+) and negative (-) screws. The use of Ground
(GND) optional; it connects to the CSG14H chassis. Ensure that each lead is securely
tightened from the top, as shown here.
NOTE: Always use a voltmeter to measure the voltage of the incoming power supply
and figure out the +ve potential lead or -ve potential lead. The more +ve potential lead
will connect to the post-labeled "+ve" and the rest to the "-ve".
The GND can be hooked up at the last.
When power is applied, the green PWR LED will illuminate.
3.8 Connecting Ethernet Media
The Magnum CSG14 Series Converter Switch can be connected to two media
types i.e. fiber and copper (RJ-45) types, run at 1000BASE-T, 100BASE-TX, 10BASE-T
and 1000BASE-SX/LX/ZX, 100BASE-FX, or 10BASE-FL. CAT 5E cables should be
www GarrettCom com
.
.
Installation and User Guide (05/08)
48
Advertisement
Table of Contents
