Table of Contents
Advertisement
CSG14 Series Gigabit Converter Switch
NOTE : It is recommended that high quality CAT. 5E cables (which work for 10Mbps,
100Mbps and 1000Mbps) be used whenever possible in order to provide
flexibility in a mixed-speed network, since P80-series switch ports are auto-
sensing for either 10,100 or 1000Mbps. Note that the auto-cross function does
not operate, if the port is fixed or not supporting auto-negotiation.
3.8.1
Connecting Twisted Pair (RJ-45, CAT 3 or CAT 5, Unshielded or
Shielded)
The following procedure describes how to connect a 10BASE-T, 100BASE-TX
or 1000BASE-T twisted pair segment to the RJ-45 port. The procedure is the same for both
unshielded and shielded twisted pair cables.
1.
Using standard twisted pair media, insert either end of the cable with a RJ-45 plug
into the RJ-45 connector of the port. Note that, even though the connector is shielded,
either unshielded or shielded cables and wiring may be used.
2.
Connect the other end of the cable to the corresponding device.
3.
Use the LINK LED to ensure proper connectivity by noting that the LED will be
www GarrettCom com
.
.
Installation and User Guide (05/08)
50
Advertisement
Table of Contents
