Table of Contents
Advertisement
CSG14 Series Gigabit Converter Switch
illuminated when the unit is powered and proper connection is established. If this
does not help, ensure that the cable is connected properly and that the device on the
other end is powered and is not defective.
4.
For Port # 1 or 1SW, if the LINK LED is not illuminated, move the switch which
has a cross-over or up-link for linking to another hub or Switch.
3.8.2
Connecting Fiber Optic LC-type, "Small Form factor (SFF)"
The following procedure applies to installations using LC-type fiber connectors,
i.e., using LC single-mode. While connecting fiber media to LC connectors,
simply snap on the two square male connectors into the LC female jacks of the
Fiber connector until it clicks and secures.
3.8.3
Connecting Fiber Optic SC-type, "Snap-In"
The following procedure applies to installations using SC-type fiber connectors,
i.e., using multi-mode SC. While connecting fiber media to SC connectors,
simply snap on the two square male connectors into the SC female jacks of the
Fiber connector until it clicks and secures.
www GarrettCom com
.
.
Installation and User Guide (05/08)
51
Advertisement
Table of Contents
