Connections To Nics Which Support Auto-Neg Rj-45 Ports - GarrettCom Magnum CSG14 Series Installation And User Manual

CSG14 Series Gigabit Converter Switch
* Note: The use of either multi-mode or single-mode fiber to operate at 1000Mbps speed
over long distances (i.e., over approx. 400 meters) can be achieved
factors are both applied:
•
The 1000Mb fiber segment must operate in full-duplex (FDX) mode, and
•
The worst-case OPB of the fiber link must be greater than the fiber cable's
passive Attenuation.
(Attenuation = Cable loss + LED aging loss + Insertion loss + safety factor)
3.8.6 Connections to NICs which support Auto-Negotiation, RJ-45 ports
The copper ports of Magnum CSG14 Series Converter Switches will function
properly with NICs (Network Interface Cards) which support Auto-Negotiation, and the
Fast Link Pulse (FLP) coding for the 1000BASE-T signaling system. When connecting a
NIC to the CSG14 Series, it may be necessary to reload the NIC drivers on the user device
if the NIC has been communicating with a protocol other than 1000BASE-T (such as
100BASE-TX). When 1000Mb operation is agreed and in use, the Gb LED is illuminated
www GarrettCom com . .
Installation and User Guide (05/08)
55
only
if the following