SiBE811120
4.10 Sensitivity Setting of the Air Quality Sensor (Dust Sensor)
Sensitivity Setting of the Air Quality Sensor
(dust sensor)
The sensitivity of the air quality sensor can be changed.
1
Press
2
With
press
• The receiving tone sounds, one of the airflow rate lamps "
blinks for 5 seconds, and then the lamp corresponding to the set sensitivity lights up.
3
Change the sensitivity using
• Each time the button is pressed, an airflow rate lamp lights up and the sensitivity change as below.
• The sensitivity setting is indicated by the airflow rate lamps.
If the airflow rate lamps do not change, disconnect the power plug, wait at least 3 seconds, reconnect the power plug and try the
operation again from the beginning.
To raise the sensitivity:
Select the "
lamp.
To lower the sensitivity:
Select the "
lamp.
4
When you decide on the setting, point the remote controller at the unit and press
• The receiving tone sounds and the lamp corresponding to the set sensitivity blinks.
5
Remove the power plug while the set lamp is blinking, wait for 3 seconds or more, and then
insert the power plug again.
NOTE
• The sensitivity of the air quality sensor can be set whether the unit is running or stopped.
5
• If step
is not performed, the unit does not go back to the normal operating mode.
5
If step
is performed in the middle of setting, the setting can not appropriately be completed.
Photocatalytic Air Purifier L-Series
Airflow rate lamp
on the unit for 10 seconds.
pressed, point the remote controller at the unit and
.
Airflow rate lamp
(Low)" airflow rate
"Low"
(High)" airflow rate
"Standard"
"High"
(Low)", "
(Standard)" or "
(High)"
on the unit.
Sensitivity
High
The sensor more readily reacts to dust.
Normal
Default setting
Low
The sensor reacts less to dust.
Operation Manual
ON / OFF / Mode change button
OFF TIMER button
.
22
3P276413-1A
29