Table of Contents
Advertisement
Advanced Settings
Advanced Settings
If the tone emitted when the water supply lamp lights up bothers you
Notification Tone Setting
Setting procedures
Hold down
turned off.
• Each time
[When the setting is changed to OFF]
A short beep sounds and the humidity lamp
[When the setting is changed to ON]
A short beep sounds and the humidity lamp
Note
• This function is useful for use during sleep hours etc.
• Settings are remembered even if the unit is unplugged.
• The error notification alarm cannot be turned off.
When the sensitivity of the dust/PM2.5 sensor does not meet your preferences
Dust / PM2.5 Sensor Sensitivity Setting
Setting procedures
1.
Hold down
remote controller while pressing
• This setting change can be performed when the unit is on or off.
2.
Release both buttons when a short beep sounds.
• One of the FAN lamps (
corresponding to the currently set sensitivity will light up.
3.
Press
on the unit to change the sensitivity setting.
• Each press cycles between the FAN lamps allowing you to change the sensitivity.
To set sensitivity High
Select the FAN lamp
To set sensitivity Low
Select the FAN lamp
• Setting is indicated using the FAN lamps. If the FAN lamps do not change, unplug the unit, wait at least 5 seconds, then
re-insert the power supply plug and repeat the above procedure from the beginning.
4.
Press
on the remote controller after selecting the new setting.
• A short beep sounds and the new setting will blink. Unplug the unit while the lamp is blinking, wait at least 5 seconds,
and then re-insert the power supply plug. Setting is now complete.
• If this procedure is not performed, the unit will not return to regular operation mode.
Note
• Settings are remembered even if the unit is unplugged.
21
Unit
for about 3 seconds with the power supply plug inserted and the unit
is held down for about 3 seconds, the setting switches between ON and OFF.
Remote controller
on the unit for about 5 seconds and when a short beep sounds, press
on the unit.
(Low),
(Standard),
(Turbo).
(Low).
(Standard) blinks for about 5 seconds.
(Standard) lights up for about 5 seconds.
Unit
(Turbo)) will blink for about 5 seconds and then the lamp
The sensor is
High
(Turbo)
highly receptive.
Setting at time
(Standard)
Normal
of purchase
The sensor is
(Low)
Low
slightly receptive.
*Setting at time of purchase
ON*
ON*
OFF
OFF
Blinking
Lit up
*Setting at time of purchase
High
High
Normal*
Normal*
Low
Low
on the
Advertisement
Table of Contents
Troubleshooting
