Setting Dust/Pm2.5 Sensor Sensitivity - Daikin MC55VBFVM3 Operation Manual

Advanced Settings
Advanced Settings
When the sensitivity of the dust/PM2.5 sensor does not meet your preferences

Setting Dust/PM2.5 Sensor Sensitivity

Setting procedures
1.
Hold down
remote controller while pressing
• This setting change can be performed when the unit is on or off.
2.
Release both buttons when a short beep sounds.
• One of the FAN lamps (
corresponding to the currently set sensitivity will light up.
3.
Press on the unit to change the sensitivity setting.
• Each press cycles between the FAN lamps allowing you to change the sensitivity.
To set sensitivity High
Select the FAN lamp
To set sensitivity Low
Select the FAN lamp
• Setting is indicated using the FAN lamps. If the FAN lamp does not change, unplug the unit, wait at least 5 seconds, then
reinsert the power supply plug and repeat the above procedure from the beginning.
4.
Press on the remote controller after selecting the new setting.
• A short beep sounds and the new setting will blink. Unplug the unit while the lamp is blinking, wait at least 5 seconds,
and then reinsert the power supply plug. Setting is now complete.
• If this procedure is not performed, the unit will not return to regular operation mode.
Note
• Settings are remembered even if the unit is unplugged.
15
Remote controller
on the unit for about 5 seconds and when a short beep sounds, press
on the unit.
(Low), (Standard),
(Turbo).
(Low).
Unit
(Turbo)) will blink for about 5 seconds and then the lamp
The sensor is
(Turbo) High
highly receptive.
Setting at time
Normal
(Standard)
of purchase
The sensor is
(Low)
Low
slightly receptive.
*Setting at time of purchase
High Normal* Low
High Normal* Low
on the