Cleaning Of Unit1 And Unit2 - Daikin MC70L3VM L-Series Service Manual

Operation Manual
4.8

Cleaning of UNIT1 and UNIT2

Cleaning of UNIT1 and UNIT2
UNIT1:
If the "UNIT1" lamp lights
Time for
UNIT2:
cleaning
Once every 3 months or if
the "UNIT2" lamp lights
Cleaning
Soak, drain and dry
method
If marking is a concern, clean the unit even if the "UNIT1" and "UNIT2"
lamps do not light.
For details on removing and attaching each part,
see .
Page 17.
Procedure
Remove the parts.
Use a vacuum cleaner to remove the
dust.
Soak in lukewarm water or water.
(About 1 hour)
Remove dirt with a piece of cloth, soft
brush, etc.
Wear rubber
gloves.
Rinse in running water and drain.
Dry in a well-ventilated, shaded
place. (About 1 day)
Attach the parts.
1) Ionising frame
• Remove dirt from plastic parts with a soft piece of cloth.
• Use a cotton swab, etc. to wipe away dirt in recesses and places where fingers do not fit.
• Do not leave any lint from cleaning cloths behind. Lint may lead to malfunctions.
19
26
Wipe
1) Ionising frame
Wear rubber
gloves.
(Remove dirt after soaking but before drying.)
UNIT1
(Plasma ioniser)
1) Ionising frame
2) Ionised wire (rear) 3) Opposing pole
plates
UNIT1
2) Ionised wire
Page 17, 18.
Wipe
For details, see 1) and
2) below.
Page 17, 18.
SiBE811120
UNIT2
(Streamer unit)
4) Streamer unit
3) Opposing pole plates
Page 18.
Wear rubber
Rub
gloves.
Page 18.
Wear rubber
gloves.
* Remove dirt from recesses
with a cotton swab, etc.
Photocatalytic Air Purifier L-Series