Advanced Settings; Setting Dust/Pm2.5 Sensor Sensitivity - Daikin MC40VBFVM3 Operation Manual

Advanced Settings

When the sensitivity of the dust/PM2.5 sensor does not meet your preferences

Setting Dust/PM2.5 Sensor Sensitivity

1.
Hold down for about 5 seconds and when a short beep sounds, press
• This setting change can be performed when the unit is on or off.
2.
When a short beep sounds, release
• One of the FAN lamps (
corresponding to the currently set sensitivity will light up.
3.
Press to change the sensitivity setting.
• Each press cycles between the FAN lamps allowing you to change the sensitivity.
To set sensitivity High
Select the FAN lamp
To set sensitivity Low
Select the FAN lamp
• Setting is indicated using the FAN lamps. If the FAN lamp does not change, unplug the unit, wait at least 5 seconds, then
reinsert the power supply plug and repeat the above procedure from the beginning.
4.
Press after selecting the new setting.
• A short beep sounds and the new setting will blink. Unplug the unit while the lamp is blinking, wait at least 5 seconds,
and then reinsert the power supply plug. Setting is now complete.
• If this procedure is not performed, the unit will not return to regular operation mode.
Note
• Settings are remembered even if the unit is unplugged.
and
(Low), (Standard), (Turbo)) will blink for about 5 seconds and then the lamp
(Turbo)
(Turbo).
(Standard)
(Low).
(Low)
.
The sensor is
High
highly receptive.
Setting at time
Normal
of purchase
The sensor is
Low
slightly receptive.
Advanced Settings
*Setting at time of purchase
High Normal* Low
High Normal* Low
while pressing .
12