Removing And Attaching Each Part - Daikin MC70L3VM L-Series Service Manual

Operation Manual
4.7

Removing and Attaching Each Part

Removing and Attaching Each Part
Remove
1
Remove the front panel.
• Push the 2 clips (right and left), and pull the front panel
upward and remove it.
Front panel
2
Remove the prefilter.
• Hold the indent and pull the prefilter. Then, unhook the
tabs (4 locations) of the prefilter from the holes (2 each on
the right and left) of UNIT1.
Pull the prefilter to remove it.
Tabs
(2 each on
right an left)
Prefilter
3
Remove UNIT1.
• Holding UNIT1 by the handles, pull UNIT1 upward and
remove it.
Handles
1)
Pull
4
Remove the deodorising catalyst unit.
• Holding the deodorising catalyst unit by the handles, pull • Holding the deodorising catalyst unit by the handles, pull
the deodorising catalyst unit upward and remove it. the deodorising catalyst unit upward and remove it.
Handles
1)
Pull
17
24
Push
Clip
(1 each on right and left)
Note
Use a vacuum cleaner to
remove the dust before
removing the prefilter.
2)
Up
UNIT1
2)
Up
Deodorising catalyst unit
Attach
1
Attach the deodorising catalyst unit.
• Holding the deodorising catalyst unit by the handles, fit the
projections into the grooves (4 locations) at the bottom of
the main unit and, press the deodorising catalyst unit into
the main unit.
Handles
1)
Fit here.
Deodorising
2) Press the deodorising catalyst unit
catalyst unit
until you hear clicking sound.
2
Attach UNIT1.
• Holding UNIT1 by the handles, fit the projections into the
grooves (2 locations) at the bottom of the main unit, and
press UNIT1 into the main unit.
Handles
1)
Fit here.
UNIT1
2) Press UNIT1 until you
hear clicking sound.
3
Attach the prefilter.
• Fit the tabs (4 locations) of the prefilter into the holes
(2 each on the right and left) of UNIT1.
Upper left tab (1 location)
(The upper left tab is shaped
differently from the others.)
Prefilter
4
Attach the front panel.
• Fasten the top hooks (2 locations) of the front panel to the
top grooves (2 locations) of the main unit and then close
the front panel.
Top hooks (2 locations)
Top grooves
(2 locations)
1) Fasten the
hooks.
Front panel
2) Press the front panel until
[View from above]
If the front panel is improperly set, the safety switch
may be activated. Operation may not start.
Photocatalytic Air Purifier L-Series
SiBE811120
UNIT1
Other tabs
(3 locations)
you hear clicking sound.
Page 16.