Cleaning of UNIT1 and UNIT2
UNIT1:
If the "UNIT1" lamp lights
Time for
UNIT2:
cleaning
Once every 3 months or if
the "UNIT2" lamp lights
Cleaning
Soak, drain and dry
method
If marking is a concern, clean the unit even if the "UNIT1" and "UNIT2"
lamps do not light.
For details on removing and attaching each part,
see
.
►
Page 17.
Procedure
Remove the parts.
Use a vacuum cleaner to remove the
dust.
Soak in lukewarm water or water.
(About 1 hour)
Remove dirt with a piece of cloth, soft
brush, etc.
Wear rubber
gloves.
Rinse in running water and drain.
Dry in a well-ventilated, shaded
place. (About 1 day)
Attach the parts.
1) Ionising frame
(Remove dirt after soaking
but before drying.)
•
Remove dirt from plastic
parts with a soft piece of
cloth.
•
Use a cotton swab, etc. to
wipe away dirt in recesses
and places where fi ngers do
not fi t.
•
Do not leave any lint from
cleaning cloths behind. Lint
may lead to malfunctions.
19
Wipe
Ionising frame / Ionised wire
►
Page 9.
►
Page 17, 18.
Wear rubber gloves.
Cloth
Cotton
swab
►
Page 10.
►
Page 17, 18.
Wear rubber
gloves.
* Remove dirt from recesses
with a cotton swab, etc.
UNIT1
(Plasma ioniser)
Ionising frame
Ionised wire (rear)
Opposing pole
plates
UNIT1
Wipe
For details,
1) Ionising frame
2) Ionised wire
2) Ionised wire (8 locations)
•
UNIT2
(Streamer unit)
Streamer unit
Opposing pole plates
►
Page 18.
Wear rubber gloves.
Cloth
Brush
Rub
►
Page 18.
Remove dirt from the ionised wires and
surrounding plastic parts with a soft
piece of cloth.
Wear rubber
gloves.
* Wipe the ionised wires gently.
Pulling on them forcefully may cause
them to snap.