Cleaning Of Unit1 And Unit2 - Daikin MC70LBFVM Operation Manual

Cleaning of UNIT1 and UNIT2

UNIT1:
If the "UNIT1" lamp lights
Time for
UNIT2:
cleaning
Once every 3 months or if
the "UNIT2" lamp lights
Cleaning
Soak, drain and dry
method
If marking is a concern, clean the unit even if the "UNIT1" and "UNIT2"
lamps do not light.
For details on removing and attaching each part,
see .
► Page 17.
Procedure
Remove the parts.
Use a vacuum cleaner to remove the
dust.
Soak in lukewarm water or water.
(About 1 hour)
Remove dirt with a piece of cloth, soft
brush, etc.
Wear rubber
gloves.
Rinse in running water and drain.
Dry in a well-ventilated, shaded
place. (About 1 day)
Attach the parts.
1) Ionising frame
(Remove dirt after soaking
but before drying.)
• Remove dirt from plastic
parts with a soft piece of
cloth.
• Use a cotton swab, etc. to
wipe away dirt in recesses
and places where fi ngers do
not fi t.
• Do not leave any lint from
cleaning cloths behind. Lint
may lead to malfunctions.
19
Wipe
Ionising frame / Ionised wire
► Page 9. ► Page 17, 18.
Wear rubber gloves.
Cloth
Cotton
swab
► Page 10. ► Page 17, 18.
Wear rubber
gloves.
* Remove dirt from recesses
with a cotton swab, etc.
UNIT1
(Plasma ioniser)
Ionising frame
Ionised wire (rear) Opposing pole
plates
UNIT1
Wipe
Cloth
For details,
1) Ionising frame
Brush
2) Ionised wire
2) Ionised wire (8 locations)
• Remove dirt from the ionised wires and
surrounding plastic parts with a soft
piece of cloth.
* Wipe ionized wires gently.
UNIT2
(Streamer unit)
Streamer unit
Opposing pole plates
► Page 18.
Wear rubber gloves.
Rub
► Page 18.
Wear rubber
gloves.
Pulling on them forcefully may cause
them to snap.