Fujitsu MBA3073RC SERIES Technical Manual page 381

Table 6.5 Sense data error classification (3/3)
K* C* Q*
6 29 xx Power on, reset, or HARD RESET occurred
The HDD was initialized by a Power on or HARD RESET
sequence.
6 2A 01 Mode parameters changed
The MODE SELECT parameters were changed by
another INIT.
6 2F 00 Commands cleared by another INIT
Commands were cleared by another INIT.
6 3F 01 Microcode has been changed
02 Changed operation definition
7 27 00 Write protected
Access to a read protected or write protected.
B 03 xx Peripheral device write fault
11 xx Unrecovered read error
13 xx Sync byte not found for data field
14 xx Record not found
15 xx Mechanical positioning error
B 0E 01 Information Unit Too Short
02 Information Unit Too Long
47 01 Information Unit iuCRC Error Detected
4B 01 Invalid Target Port Transfer Tag Received
4B 02 Too Much Write Data
4B 03 ACK/NAK Time Out
4B 04 NAK Received
4B 05 Data Offset Error
4B 06 Initiator Response Timeout
An unrecoverable SAS related error occurred in the
command execution sequence.
B 4E 00 Overlapped commands attempted
Before execution of a command was completed, a new
command was issued by the same INIT.
E 1D 00 Miscompare during verify operation
Data failed to match in the Byte check mode of the
Verify command.
* K: Sense Key
Q: Additional Sense Code Qualifier
C141-C013
6.2 INIT Error Recovery Methods (Recommended)
Outline of Error
C: Additional Sense Code
L: Logging Necessary? (shown in Section 6.2.3)
Recovery Method
L*
(See Table 6.6.)
None 14
None 21
None 25
None 27
None 15
Need 12
Need 6
None 2
None 24
377