Fujitsu MBA3073RC SERIES Technical Manual page 372

Sense Data and Error Recovery Methods
Table 6.4 Additional Sense Code and Additional Sense Code Qualifier (4/6)
C* Q* Name
31 00 Medium format corrupted
01 FORMAT command failed
32 00 No defect spare location
available
01 Defect list update failure
37 00 Rounded parameter
3E 03 Logical unit failed Self-Test
04 Logical unit unable to update
3F 01 Microcode has been changed
02 Changed operating definition
05 Device identifier changed
40 nn Diagnostic failure on
component "nn"
* C: Additional Sense Code, Q: Additional Sense Code Qualifier
368
Explanation
The media format is different from the original format. (The
media was not formatted after the data format specification was
changed by the MODE SELECT command.)
For some reason, formatting cannot be completed and
reformatting is necessary.
No usable alternate block area exists. Or alternate block
processing cannot be performed due to control table overflow.
Updating of the defect list (G List) failed.
Rounding processing of the MODE SELECT parameter
specified by the command was performed.
The test segment error occurred during the Self-Test
The HDD failed to update the Self-Test result log
Microcode was changed by another INIT.
Operating definition was changed.
Device identifier was changed.
An error was detected in self-diagnosis. ("nn" is a Fujitsu unique
code)
81: Buffer RAM compare error/bus error
83: HDC register check error
84: Firmware header/check sum error
86: Parameter header/check sum error
88: Drive Serial No. unmatch
89: DE type unmatch
8F: Other MPU peripheral circuit diagnostic error
92: Spindle motor firmware initialize error
Sense
key
3
3
4
4
1
4
4
6
6
6
4
C141-C013