Fujitsu MBA3073RC SERIES Technical Manual page 380

Sense Data and Error Recovery Methods
Table 6.5 Sense data error classification (2/3)
K* C* Q*
3 31 00 Medium form at corrupted
31 01 FORMAT command failed
The data format on the disk media is not correct.
The data format on the disk media is not correct.
4 03 xx Peripheral device write fault
This is an error of the disk drive's write system.
32 01 Defect list update failure
These are errors detected in the operation of the disk
drive.
4 32 00 No defect spare location available
No usable alternate blocks exist on the disk drive.
4 40 nn Diagnostic failure on component 'nn'
An error was detected in the HDD's self-diagnosis.
4 44 nn Internal target failure
An internal hardware error or a microcode detection
error was detected in the HDD.
4 4C xx Calibration failed
C4 xx Drive failure
The initial seek was terminated abnormally. Or, a
serious error was detected in the drive's control system.
5 20 00 Invalid command operation code
21 00 Logical block address out of range
24 00 Invalid field in CDB
25 00 Logical unit not supported
26 00 Invalid field in parameter list
There is an error in the command specification contents.
* K: Sense Key
Q: Additional Sense Code Qualifier
376
Outline of Error
C: Additional Sense Code
L: Logging Necessary? (shown in Section 6.2.3)
Recovery Method
L*
(See Table 6.6.)
Need 18
Need 7
None 19
Need 13
Need 20
Need 10
None 2
C141-C013