Fujitsu MBA3073RC SERIES Technical Manual page 371

Table 6.4 Additional Sense Code and Additional Sense Code Qualifier (3/6)
C* Q* Name
1C 01 Primary defect list not found
02 Grown defect list not found
80 SA information list not found The SA information (MODE SELECT parameter) header is
1D 00 Miscompare during verify
operation
80 Miscompare during self-
configuration
1F 00 Partial Defect List Transfer
20 00 Invalid command operation
code
21 00 Logical block address out of
range
24 00 Invalid field in CDB
25 00 Logical unit not supported
26 00 Invalid field in parameter list There is an error in the parameter list specifications transferred
27 00 Write protected
29 01 Power on occurred
02 SCSI Bus Reset Occurred
03 TARGET RESET function
occurred
04 Firmware Internal Reboot
07 I_T Nexus Loss occurred
2A 01 Mode parameter changed
03 Reservations preempted
04 Reservations released
05 Registrations preempted
2F 00 Command cleared by another
INIT
* C: Additional Sense Code, Q: Additional Sense Code Qualifier
C141-C013
Explanation
The defect list (P List) header is incorrect.
The defect list (G List) header is incorrect.
incorrect.
Comparison of data transferred from the INIT by a VERIFY
command (when the Byte Check mode was specified) with data
read from the disk media was terminated unsuccessfully.
There is an unmatch to compare read data with write data during
self-configuration.
Read Defect Data command (37h) cannot transfer all the Defect
data in the target because the numbers of defect exceeded the
maximum.
CDB byte 0 (operation code) is illegal.
A logical block address which exceeds the drive's maximum
value was specified.
There is an error in a specification in the CDB.
An illegal LUN was specified.
from the INIT during command execution.
A write operation was attempted in a write protected area. Or a
write operation is prohibited at the external operation panel.
Microcode was downloaded immediately after power on.
A HARD_RESET primitive was received.
A Logical Unit RESET was received.
Reboot occurred in the firmware
I_T Nexus Loss Time (Mode Page 19) was expired.
The MODE SELECT parameter values were changed by another INIT.
A persistent reserve state was cleared by another INIT.
A persistent reserve state was released
A persistent reserve state was preempted by another INIT.
A command was forcibly terminated by another INIT during
execution or queuing.
By a CLEAR TASK SET
The sense hold state was entered when the QErr bit was set on
"1."
6.1 Sense Data
Sense
key
3
3
3
E
E
1
5
5
5
5
5
7
6
6
6
6
6
6
6
6
6
6
367