Table of Contents
Advertisement
a.
Page code
This field identifies which log page is being transferred.
The log pages that can be transferred by this command are shown in Table 4.21.
Page Code
01
02
03
05
06
0D
0E
0F
10
15
18
b. Page length
This field specifies the length in bytes of the following log parameters. If the
application client sends a page length that results in the truncation of any
parameter, the device server terminates the command with CHECK CONDITION
status (ILLEGAL REQUEST [=5] / Invalid field in parameter list [=26-00]).
The log pages contain one or more special data structures called log parameters as
shown below. Each log parameter begins with a 4-byte parameter header followed
by one or more bytes of "Parameter Value" data.
C141-C013
Table 4.21 Page code
Description
Buffer Overrun/Underrun Page
Write Error Counter Page
Read Error Counter Page
Verify Error Counter Page
Non-medium Error Page
Temperature Page
Start-stop Cycle Counter Page
Application Client Log Page
Self-Test Result Log Page
Background Medium Scan Page
Protocol Specific Port Log Page
4.1 Control/Sense Commands
Changeable Parameter
Disable
Enable
Enable
Enable
Enable
Disable
Enable only 0002
Enable
Disable
Disable
Disable
189
Advertisement
Table of Contents
