Show Flowcontrol - Cisco Catalyst 4500 Series Command Reference Manual

Cisco ios command reference release ios xe 3.4.0sg and ios 15.1(2)sg
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches

show flowcontrol

To display the per-interface status and statistics related to flow control, use the show flowcontrol
command.
Syntax Description
module slot
interface interface
Defaults
This command has no default settings.
Command Modes
Privileged EXEC mode
Command History
Release
12.1(8a)EW
12.2(25)EW
Usage Guidelines
Table 2-26 describes the fields in the show flowcontrol command output.
Table 2-26
Field
Port
Send-Flowcontrol-Admin
Send-Flowcontrol-Oper
Receive-Flowcontrol-Admin
Receive-Flowcontrol-Oper
RxPause
TxPause
OL-27596 -01
show flowcontrol [module slot | interface interface]
(Optional) Limits the display to interfaces on a specific module.
(Optional) Displays the status on a specific interface.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for the 10-Gigabit Ethernet interface was introduced on the Catalyst 4500
series switch.
show flowcontrol Command Output
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
Description
Module and port number.
Flow-control administration. Possible settings: on indicates the local
port sends flow control to the far end; off indicates the local port does
not send flow control to the far end; desired indicates the local end
sends flow control to the far end if the far end supports it.
Flow-control operation. Possible setting: disagree indicates the two
ports could not agree on a link protocol.
Flow-control administration. Possible settings: on indicates the local
port requires the far end to send flow control; off indicates the local
port does not allow the far end to send flow control; desired indicates
the local end allows the far end to send flow control.
Flow-control operation. Possible setting: disagree indicates the two
ports could not agree on a link protocol.
Number of pause frames received.
Number of pause frames transmitted.
show flowcontrol
2-697

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents