Vtp V2-Mode - Cisco Catalyst 4500 Series Command Reference Manual

vtp v2-mode

vtp v2-mode
To enable version 2 mode, use the vtp v2-mode command. To disable version 2 mode, use the no form
of this command.
Syntax Description
This command has no arguments or keywords.
Defaults Disabled
Command Modes VLAN configuration mode
Command History Release
12.1(8a)EW
Usage Guidelines All switches in a VTP domain must run the same version of VTP. VTP version 1 and VTP version 2 do
not operate on switches in the same VTP domain.
If all switches in a domain are VTP version 2-capable, you only need to enable VTP version 2 on one
switch; the version number is then propagated to the other version 2-capable switches in the VTP
domain.
If you toggle the version 2 mode, the parameters of certain default VLANs will be modified.
Examples
This example shows how to enable version 2 mode in the VLAN database:
Switch(vlan-config)# vtp v2-mode
Switch(vlan-config)#
This example shows how to disable version 2 mode in the VLAN database:
Switch(vlan-config)# no vtp v2-mode
Switch(vlan-config)#
Related Commands Command
show vtp
vtp (global configuration
mode)
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-1138
vtp v2-mode
no vtp v2-mode
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Displays VTP statistics and domain information.
Configures the name of a VTP configuration storage file.
OL-27596 -01