Subscribe-To-Alert-Group Environment - Cisco Catalyst 4500 Series Command Reference Manual

subscribe-to-alert-group environment

subscribe-to-alert-group environment
To subscribe a destination profile to the Environment alert group, use the
subscribe-to-alert-group environment command.
Syntax Description severity catastrophic
disaster
fatal
critical
major
minor
warning
notification
normal
debugging
Defaults normal
Command Modes cfg-call-home-profile
Command History Release
12.2(52)SG
Usage Guidelines To enter profile call-home configuration submode, use the profile command in call-home configuration
mode.
The Environment alert group can be configured to filter messages based on severity.
Examples This example shows how to configure the "environmental" alert-group with "severity notification":
Switch(config)# call-home
Switch(cfg-call-home)# profile cisco
Switch(cfg-call-home-profile)# subscribe-to-alert-group environment severity notification
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-1030
subscribe-to-alert-group environment [severity catastrophic | disaster | fatal | critical | major |
minor | warning | notification | normal | debugging]
(Optional) Specifies network wide catastrophic failure (highest severity).
(Optional) Specifies significant network impact.
(Optional) Specifies that the system is unusable (system log level 0).
(Optional) Specifies that immediate attention is needed (system log level 1).
(Optional) Specifies a major condition (System log level 2).
(Optional) Specifies a minor condition (System log level 3).
(Optional) Specifiies a warning condition (System log level 4).
(Optional) Specifies an informational message (System log level 5).
(Optional) Specifies returning to a normal state (System log level 6).
(Optional) Specifies a debugging message (Lowest severity).
Modification
Support was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-27596 -01