Template Data Timeout (Netflow-Lite Exporter Submode) - Cisco Catalyst 4500 Series Command Reference Manual

template data timeout (netflow-lite exporter submode)

template data timeout (netflow-lite exporter submode)
NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
Note
To specify a template data timeout for the NetFlow-lite collector, use the template data timeout
command. To delete the value, use the no form of this command.
Syntax Description
seconds
Defaults 1800 seconds
Command Modes netflow-lite exporter submode
Command History Release
15.0(2)SG
Usage Guidelines Default timeout value is 1800 seconds or 30 minutes. The timeout value configured really depends on
the collector and how often it needs the templates to be refreshed.
Examples This example shows how to specify a template data timeout for the NetFlow-lite collector:
Switch# config terminal
Switch(config)# netflow-lite exporter exporter1
Switch(config-netflow-lite-exporter)# destination 5.5.5.6
Switch(config-netflow-lite-exporter)# source 5.5.5.5
Switch(config-netflow-lite-exporter)# transport udp 8188
Switch(config-netflow-lite-exporter)# ttl 128
Switch(config-netflow-lite-exporter)# cos 7
Switch(config-netflow-lite-exporter)# dscp 32
Switch(config-netflow-lite-exporter)# template data timeout 1
Switch(config-netflow-lite-exporter)# options sampler-table timeout 1
Switch(config-netflow-lite-exporter)# options interface-table timeout 1
Switch(config-netflow-lite-exporter)# export-protocol netflow-v9
Switch(config-netflow-lite-exporter)# exit
Switch(config)#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-1078
template data timeout seconds
no dscp dscp-value
Specifies a template data timeout value for the NetFlow-lite collector.
Modification
Support for this command was introduced on the Catalyst 4948E and
Catalyst 4948E-F Ethernet switches.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-27596 -01