Vmps Retry - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

vmps retry

To configure the per-server retry count for the VLAN Query Protocol (VQP) client, use the vmps retry
command. To return to the default setting, use the no form of this command.
Syntax Description
count
Defaults
The retry count is 3.
Command Modes Global configuration mode
Command History Release
12.1(13)EW
Usage Guidelines You can verify your setting by entering the show vmps command and examining information in the
Server Retry Count row.
Examples This example shows how to set the retry count to 7:
Switch(config)# vmps retry 7
Related Commands Command
show vmps
OL-27596 -01
vmps retry count
no vmps retry
Number of attempts to contact the VLAN Membership Policy Server (VMPS) by the
client before querying the next server in the list; valid values are from 1 to 10.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
Description
Displays the VLAN Query Protocol (VQP) version,
reconfirmation interval, retry count, VLAN Membership Policy
Server (VMPS) IP addresses, current servers, and primary
servers.
vmps retry
2-1125