Spanning-Tree Mst Configuration - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

spanning-tree mst configuration

To enter the MST configuration submode, use the spanning-tree mst configuration command. To return
to the default MST configuration, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults The default settings are as follows:
•
•
•
•
Command Modes Global configuration mode
Command History Release
12.1(12c)EW
Usage Guidelines The MST configuration consists of three main parameters:
•
•
•
By default, the value for the MST configuration is the default value for all its parameters.
The abort and exit commands allow you to exit the MST configuration submode. The difference
between the two commands depends on whether you want to save your changes or not.
The exit command commits all the changes before leaving MST configuration submode. If you do not
map the secondary VLANs to the same instance as the associated primary VLAN, when you exit the MST
configuration submode, a message displays and lists the secondary VLANs that are not mapped to the
same instance as the associated primary VLAN. The message is as follows:
These secondary vlans are not mapped to the same instance as their primary:
->3
The abort command leaves the MST configuration submode without committing any changes.
OL-27596 -01
spanning-tree mst configuration
no spanning-tree mst configuration
No VLANs are mapped to any MST instance.
All VLANs are mapped to the CIST instance.
The region name is an empty string.
The revision number is 0.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Instance VLAN mapping (see the
Region name (see the name
Configuration revision number (see the
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
instance command)
command)
revision command)
spanning-tree mst configuration
2-997