Replacing Hydrostatic Transmission Wire - Husqvarna Rider 111 B Workshop Manual

Reparation instructions
Replacing hydrostatic transmission
wire
Rider 111 B
Removal of hydrostatic transmission wire
1 Remove the frame cover by loosening the
screws (three screws in the front and two under
the seat). Remove the front cover.
2 Loosen the hydrostatic transmission cable
locking nut 1/4 turn.
32
– English
3 Remove the hydrostatic transmission wire's front
clamp fi xed inside the middle bracket.
4 Cut off the plastic tie around the cable at the
frame situated in front of the right rear wheel.
1
5 Loosen the M5 nut (1) and remove the locking
spring (2) by the hydrostatic transmission's rear
link joint. Loosen the clamp (3) holding the cable
cover.
3
2