Xerox 4595 System Administration Manual page 85

X er o x 4 5 95 Co pi e r /P r i n te r S y s t em Ad m i ni s t r at i on G ui d e
NOTE 1: Enter address in the format "xxx.xxx.xxx.xxx"
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.
NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Save/Select Next.
g. Select Save.
h. Configure TCP/IP - Subnet Mask and TCP/IP - Gateway
Address as the above.
NOTE 1: Enter address in the format "xxx.xxx.xxx.xxx"
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255. However,
you cannot use 0 between non-zero values.
NOTE 3: If you do not wish to set the gateway address,
enter "0.0.0.0."
4. Select Close repeatedly until the System Settings screen is
displayed.
5. Select Exit.
6. After the machine is restarted, print out the Printer Settings
List to confirm that the ports are enabled and TCP/IP is
configured.
4 . E - ma i l
4-5