Other Settings - Xerox 4595 System Administration Manual

Receiving Buffer - IPP
Receiving Buffer -
EtherTalk
Receiving Buffer - Port

Other Settings

X er o x 4 5 95 Co pi e r /P r i n te r S y s t em Ad m i ni s t r at i on G ui d e
NOTE: Notice that print data exceeding the set memory
capacity is not accepted. In such cases, select Hard Disk or
Off.
• Hard Disk Spool: When selected, the machine will use
spooling. The receiving buffer for spooling uses the hard disk.
• Off: When Off is selected, the machine will not use spooling.
While IPP print processing is being carried out for one client,
Spool
data cannot be received over the same interface from another
client. Set a value for the dedicated IPP receiving buffer
memory capacity from 64 to 1024 KB, in 32 KB increments.
• Hard Disk: When selected, the machine will use spooling.
The receiving buffer for spooling uses the hard disk.
Set the EtherTalk receiving buffer. Set a value from 1024 to 2048
KB, in 32 KB increments.
Set the Port9100 receiving buffer. Set a value from 64 to 1024
KB, in 32 KB increments.
9100
For information about each of the following items, refer to
Overview of features page 1, and also refer to the appropriate
chapter (see the Table of contents) in the PostScript User Guide.
Make settings relating to the paper used in the machine.
Select Other Settings.
1.
Select the item to be set or changed, and select Change
2.
Settings.
Select the item to be changed.
3.
Select Save.
4.
8 . S e t ups
8-127