Configuration On The Computer; Ethertalk; Preparations; Configuration Procedure - Xerox 4595 System Administration Manual

2. C on f ig u r at i on

EtherTalk

Preparations

Configuration procedure

2- 1 2

Configuration on the computer

This section describes the configuration procedure for the
computer.
To print from the machine, the computer needs to have the print
driver installed.
For information about the usable operating systems, refer to
"Supported operating systems" on page 1-7.
Refer to the manual contained in the "CentreWare Utilities" CD-
ROM for the print driver installation procedure.
The following item is required when using an EtherTalk network:
• A network environment where EtherTalk can be used.

Overview

The machine can be connected to computers using an EtherTalk
network.
The following is the procedure to connect the machine to
EtherTalk network:
• Configuration on the Machine: Set up EtherTalk on the
machine.
• Configuration on the Computer: Install the print driver.
X e r o x 4 5 95 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e