10. Back Panel Interface
10. Back Panel Interface
10.1 Power Inlet
A Neutrik NAC3 Series PowerCon connector rated at 32 A is fitted to the rear of the PLM for AC mains
input. The power cable (AC cord) supplied with the PLM has the mating connector ready-fitted, but may
require a mains (AC) plug specific to your country to be fitted to the other end. See section 5.5 for wiring
details.
10.1.1 PowerCon
If it is necessary to rewire the PowerCon connector, or to make custom power cables for your particular
installation, please observe the following connection details:
PowerCon Pin
L
N
Table 10.1.1: PowerCon connector wiring and pin out
10.2 Audio Input and Links
10.2.1 Analog inputs and links
INPUT
1
Figure 10.2.1a: Rear panel analog input/link field
The electronically-balanced analog inputs are on XLR3F connectors. The Link outputs on XLR3M connectors
are directly paralleled to the inputs. All XLRs are wired to IEC268 as follows in figure 10.2:
Pin 1:
Ground/shield
Pin 2:
Hot (+)
Pin 3:
Cold (-)
Figure 10.2.1b: Analog XLR wiring and pin out
70
PLM Series Operation Manual rev 1.1.3
wiring details
®
230 V Version
115 V Version
Brown
Black
Blue
White
Green/Yellow
Green
LINK
1
INPUT 2
LINK 2
PIN 1: SCRN 2: POS 3: NEG
I
F
ANALOG WITH
SO-
LOAT
TM