Lab.gruppen PLM series Operation Manual page 14

5. Installation
Note that the support brackets are reversible and may be fitted to point either to the front or rear of the rack.
The orientation used in a particular situation will depend on the depth of the rack and the position of the rear
rack rails.
Two mounting methods are possible; note that the method shown in figure 5.3b additionally provides extra
security against unauthorized removal.
For situations where rapid removal and replacement of units is of paramount importance, the method shown
in figure 5.3c may be used as it does not involve any permanently secured fixing at the rear of the unit.
Figure 5.3a: Rear support mounting hardware
Figure 5.3b: Use washer for fixed installation
14
PLM Series Operation Manual rev 1.1.3
x2
x2 x2 x2
Figure 5.3c: Use tube for slide-on installation