Meter View 2 - Module View - Lab.gruppen PLM series Operation Manual

9. Front Panel Interface
9.12.2 Meter View 2 – Module View
MODULE METERS V
A I
1 P
FAULT/WARNING L
CL3W V
A
I
-24 2 P
L
1 AUX V
A
I
-50 3 P
L
V
B
I
1 P
L
Figure 9.12.2: Module meter view
Module View provides further signal level information in the form of additional power output meters.
Frame block:
▸
Line 1 MODULE METERS flag – confirms Module view
▸ Frame name – displays Frame ident confirming "which PLM this is". If no name is assigned
Line 2
then the PLM model name will be displayed.
▸ Line 3 (blank)
▸
Line 4 Frame fault/warning – displays text describing problem in event of a Frame fault or warning
Input blocks:
▸ Line 1 Module name – displays name given to Lake Processing Modules A and B (if any)
▸
Line 2 (blank)
▸ Input meter showing signal level at the Module input. A numeric indication of peak level is also
Line 3
provided at the right-hand end of the meter.
▸ Line 4 (blank)
Block 4 is unused in METER mode.
Output blocks:
▸
Line 1 Output voltage meter, denoted by 'V'. This meter indicates the PLM's power output stage
voltage relative to its clip level.
▸ Line 2 Output current meter, denoted by initial 'I'. This meter indicates the current the PLM power
output stage is driving into its load, relative to the maximum permissible current the fixed CPL allows.
▸
Line 3 Output power meter, denoted by initial 'P'. This meter indicates the instantaneous output
power being developed in the load relative to the PLM's maximum output power capability.
▸ Line 4 Gain reduction meter, denoted by L. This meter indicates the degree of limiting being applied by
the ISVPL and/or the LimiterMax within the Lake processing system.
52
PLM Series Operation Manual rev 1.1.3
∞
-
∞
-
∞
-
∞
-