Technical Specifications - Lab.gruppen PLM series Operation Manual

13. Technical Specifications

13. Technical Specifications
PLM 14000
General
Number of input channels
Number of output channels
Peak total output all channels driven
Max. Peak output voltage per channel
Max. output current per channel
Max. Output Power
All channels driven
Channel A, while channel B is driven at -3dB
All channels driven into optimal impedance interval
Audio Performance
THD + N 20 Hz - 20 kHz for 1 W
THD + N at 1 kHz and 1 dB below clipping
Dynamic range with digital inputs (for all supported sample rates)
Dynamic range with analog inputs
Frequency response (1 W into 8 ohms, 20 Hz - 20 kHz)
Input Common Mode Rejection (CMR) 20 Hz to 1 khz
Internal sample rate
Internal data path
Product propagation delay, best case (96 kHz AES)
Product propagation delay, analog input
Sample Rate Converters
THD + Noise
Analog to Digital inputs
THD + Noise
AES / EBU inputs
Supported resolutions
Supported sample rates
Dante Audio Network
Supports redundant paths
Flexible topology
Network latency
Device presets
Local memory locations for the settings of the product
Limiters
Adjustable Inter-Sample Voltage Peak Limiter (ISVPL)
Current Peak Limiter < 300 ms
Current Average Limiter (CAL) > 300 ms
LimiterMax (rms and peak limiters)
– MaxRMS (rms voltage limiter)
– MaxPeak (peak voltage limiter)
Gain
Amplifi er gain
Analog attenuator
Back panel interface
AES / EBU / I/O (input + link)
Analog, 2-channel I/O (input + link)
Output connectors
Auto 10/100, Auto Uplink
Control and monitoring interface
Detachable mains cord
Cooling
Front-panel user interface:
Display, daylight readable LCD
Fault/Warning/Limit/Clip indicators
Mute and soft function buttons
Standby Power button
Mute Enable button
Meter button
Menu button
Rotary Encoder
Exit button
Power
Operating voltage, 230 V / 115 V nominal
Soft start / Inrush Current Draw
Mains Power Average Limiter (PAL)
Dimensions (W/H/D)
Weight
Finish
Approvals
Note 1): Separate 230 V or 115 V versions available. Not selectable on the product.
Note 2): Assymetrically loading the output channels (as shown, for example): If one channel has reduced output power requirements, the voltage drop from the power supply will be reduced,
resulting in a higher voltage and power output for the other channel.
All specifications are subject to change without notice.
Intercooler, Class TD and Lake are national and/or international registered trademarks of Lab.gruppen AB. PLM, Powered Loudspeaker Management, R.SMPS, LoadLibrary, LoadSmart,
SpeakerSafe and ISVPL are trademarks of Lab.gruppen AB. Dolby and the double-D symbol are registered trademarks of Dolby Laboratories. Contour, Mesa Quad EQ, Mesa Parametric EQ, Raised
Cosine Equalization, LimiterMax and Iso-Float are trademarks of Dolby Laboratories. Audinate is a registered trademark of Audinate Pty Ltd. Dante and Zen are trademarks of Audinate Pty Ltd.All
other trademarks remain the property of their respective owners.
Copyright © 2009 Lab.gruppen AB.
102
All rights reserved. PLM Series Operation Manual rev 1.1.3
I N T E R N A T I O N A L C O N T A C T
2
2
14000 W
193 V
90 A peak
2 ohms
7000 W
7500 W
2)
> 7000 W into 1.8 – 2.1 ohms
<0.05%
<0.04%
>114 dB
>112 dB
+ /-0.05 dB
>78 dB
96 k
32 bit fl oating point
1.61 ms
1.68 ms
0.00003 %, 20 Hz - 20 kHz, unweighted
0.00022 %, typical at 1 kHz unweighted at +26 dBu headroom setting
0.00033 %, typical at 20 Hz and 20 kHz unweighted at +26 dBu headroom setting
≤24 bit
44.1, 48, 88.2, 96, 176.4, 192 kHz
Yes
Yes
0.8, 1.3 and 4 ms
100
17.8 - 193 V, step size 0.1 V
90 A peak
44 Arms
Yes
Yes
22 - 44 dB, step size 0.1 dB
-Inf to 0 dB, step size 0.25 dB
2 x 3-pin XLR
4 x 3-pin XLR, electronically balanced
Neutrik Speakon (2 x NLT4) or 4 Binding Posts (pairs) (must be specifi ed upon order)
2 x RJ45 EtherCon Auto 10/100, Auto Uplink
Via Ethernet for Lake Controller software
Neutrik PowerCon 32 A
Two fans, front-to-rear airflow, temperature controlled speed
2.5 inch
RGB LEDs
8 provided
On/Off
Enables muting of outputs and inputs via soft-button keypad
Toggles through meter views
Provides a menu driven interface for full function front panel control
Yes
Provides a "back" function
140-265 V / 70-135 V (45 - 66 Hz)
1)
Yes / max. 5 A
Yes
W: 483 mm (19"), H: 88 mm (2 U), Overall D: 470 mm (18.5") deep including handles and rear support.
13.5 kg (30 lbs.)
Black painted steel chassis with black painted steel / aluminum front
CE, ANSI/UL 60065 (ETL), CSA C22.2 NO. 60065, FCC
L A B . G R U P P E N A B
I N F O @ L A B G R U P P E N . C O M
w w w . l a b g r u p p e n . c o m
4 ohms 8 ohms
4300 W 2300 W
4400 W 2300 W
S W E D E N
| U S & C A N A D A C O N T A C T I N F O @ T C G - A M E R I C A S . C O M
16 ohms
1150 W
1150 W
Item no. TDS-PLM14000_V3